LaCie 4TB 2big USB 3.0 Manual de usuario descargar pdf (Pagina 20)

LaCie 2big USB 3.0 • DESIGN BY NEIL POULTON Installing Drives

User Manual page 20

To Install a Drive:

1. If the 2big USB 3.0 is conﬁgured in RAID 0, turn the device

off and unplug it. If the 2big USB 3.0 is conﬁgured in RAID

1, you can leave it turned on and continue to step 2.

2. Carefully insert the drive tray into an empty drive bay. When

the drive tray is almost ﬂush, you will feel a bit of resistance.

Press the drive tray handle ﬁrmly until the drive snaps into

place and it is in line with the back pane of the 2big USB

3.0.

3. Use the 2-in-1 tool to lock the drive lock. Turn the lock until

the grooves are vertically oriented. The drives are locked

when both locks are vertical.

TECHNICAL NOTE: Data is still accessible during a RAID 1

rebuild. The 2big USB 3.0 can be disconnected from the worksta-

tion during the rebuild; only the power must be connected.Impor-

tant Info: Drive warranty will be void if you replace the defective

drive with a drive not provided by LaCie. Drives purchased from

LaCie are shipped pre-installed in drive trays with handles.

IMPORTANT INFO: In order for rebuilding to occur in RAID 1

mode, the product must be turned on while a replacement disk

is installed.

IMPORTANT INFO: Rebuilding a RAID 1 array can take sev-

eral hours. For example, rebuilding a 1TB RAID 1 array can take

more than three hours. LaCie does not recommend removing any

drives during a rebuild.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 36 37

Sin comentarios

LaCie 4TB 2big USB 3.0 Manual de usuario Pagina 20